When wiring, cables should be laid in Stroebe, or cable channel in parallel and perpendicular to the architectural lines of the walls and ceilings, and all the vertical direction are performed using a plumb. Any wiring or cuttings should be placed in special dividing box. If you do not know where the wires are laid in the wall, you can get a lot of problems when trying to hammer a nail or something to hang. When device wiring must comply with basic safety rules. We can not work under stress. When routing the new wiring, this requirement is easily doable – you just unscrew the two plug (plugs) from the panel, or turn off the automatic fuse (circuit breaker). Mounting the one or another branch to the wire, it is necessary to produce the next stripping only once sealed with tape the first connection.
The opposite ends of the wires should be evenly cut at different levels and also insulated. Before proceeding to the wiring, it is necessary to map and select the desired material and components for electrical installations. Charting begins with the fact that on the plane home, on a scale placed all the necessary components of electrical – sockets, lamps, chandeliers, switches. When placing them, should strive to ensure that sites posting to these points were as short as possible, but at the same time that the device was comfortable to use. Excessive savings on outlet may further create problems. Therefore, before to identify the place of sockets, you need to calculate where it will be one or the other electricity user (TV, refrigerator, stove, etc.).